Description
ULTRASONIC COLLAR AGAINST Barking
_Operating Instructions_
Step 1_ * replace the battery
Battery life depends on the number of transmitted UTZ signals, the average length is approx
Moon.
Step 2_ * Equipment Test
Grasp the device to cover the speaker with your finger to mute the sound
(Figure 3). Blow on the microphone several times, the device should give a sharp one
sound. If not, check that the battery and battery are correctly installed
repeat the procedure.
Step 3_ * Adjust the microphone sensitivity
On the side of the unit you will find a switch labeled “High / Low”. First set to
Low – lower sensitivity, if the device dogs not barking, only then
increase to “High”. (Figure 4)
Step 4 – Attach the device to the collar
The thickness of the collar material should preferably be 1.6mm. Pull the collar through both
make sure that the unit is positioned directly
in the middle of the collar opposite the buckle and the dog has it on his throat (Figure 5). Microphone
they may not notice barking when the device is hanging freely on the side or collar.
Also, we recommend removing it from the collar
all pendants (Figure 6).
Step 5 * Observe the first reaction
After deploying the collar with the device dog watch closely his behavior. Dog can
be surprised and startled at the first moment. Unbarking of bark may take as well
a few days, it’s individual with every dog.
Note: Never place the device directly to the ear of a dog or man.
Keep out of reach of children. Do not bite your dog. The device is not
waterproof, do not get in contact with water. If wetting occurs (e.g.
during rain), remove the battery, shake any water out and allow it to dry.
TRAINING
Barking is a natural manifestation of all dogs. But sometimes it can be a problem for
their owners. The responsible owner should not let his dog disfigure
barking life to others.
Before you put on the dog Ultrasonic collar against barking, think in yak
the situation should be used for the first time. It should be a moment when there will be something for the dog
the easiest to unleash barking. When you train a dog in a situation it is
distracted, they may not get the training properly. E.g. if the dog first s
Putting on the collar of the bark at the moment I arrive can make you uncomfortable
the ultrasonic signal to connect right to the incoming visit and not to barking.
The initial situation with the collar deployed should take place in your presence,
observe its reaction to the transmitted ultrasound signal due to barking.
